Commercial Network Cabling
Slow Wi-Fi, dropped connections, and a closet full of unlabeled cable usually come down to the same problem: the cabling underneath it all was never done right. We pull, terminate, test, and label commercial network cabling so every drop actually performs the way it's supposed to.
Who this is for
- Office managers dealing with a rat's nest of cable behind desks or in the server closet
- Business owners moving into a space with old, undocumented, or dead cabling
- Property managers who need cabling done to code before a tenant build-out closes
- IT managers who need extra hands and a licensed low-voltage crew for a cabling project
What's included
Cat6 & Cat6A runs
New cable pulled for workstations, printers, access points, and cameras, rated for the distance and speed you actually need.
Patch panel termination
Every run landed on a labeled patch panel port, punched down and dressed correctly — not just twisted and taped.
RJ45 termination & wall plates
Clean terminations at both ends, proper wall plates and faceplates, no exposed jacks or dangling cable.
Cable testing & certification
Every drop tested with a certification tester for wire map, length, and performance before we call it done.
Labeling
Consistent port and cable labeling on both ends so anyone can trace a run without guessing.
Rack & closet organization
Patch cords managed, cable dressed into channels, and the closet left looking like someone actually planned it.
Existing cable cleanup
We trace out abandoned and dead cable, remove what's not needed, and re-terminate what is.
Troubleshooting
Intermittent drops, dead ports, and mystery outages traced back to the cable, connector, or termination causing them.
Common use cases
- New office build-out that needs cabling from the ground up
- Adding drops for new desks, printers, or access points in an existing space
- Replacing old, undersized, or damaged cabling before a network upgrade
- Cleaning up a network closet that's grown unmanageable over the years
- Pre-move cabling for a business relocating to a new suite or building
What we install & configure
Our project process
Walkthrough & scope
We walk the space, count drops, and map out pathways before quoting anything.
Pull & rough-in
Cable is pulled through ceilings, walls, or conduit with proper support and separation from power.
Terminate & test
Every end is terminated, then tested and certified with documented results.
Label & document
Ports, cables, and panels are labeled, and we hand over a simple map of what goes where.
Walkthrough & sign-off
We walk the finished work with you and confirm every drop is live before we leave.
Frequently asked questions
Related services
Cat6 Data Drops
Need a handful of new Ethernet drops for a new desk, printer, or access point without tearing the whole office apart? We scope each drop individually, run cable through the pathway that actually makes sense for your ceiling and walls, and terminate it cleanly..
Network Racks
Most network closets don't start out messy — they get that way one quick fix at a time.
Network Installation
A business network is more than a router out of the box.
Ready to get this handled?
Tell us about your space and timeline, and we'll put together a straightforward quote — no jargon, no upsell.